In addition, there is a hole in the center for the N-connector. The internal reflective aluminum layer is designed so that the laser beam does not lose energy on the surface. Given the size of the emitter, you can make a WiFi antenna reflector using a 5.25 inch laser CD. A reflector is simply a plate of electrically conductive metal. In our case, the getinax fee is bad because it is difficult to get. So, the figure eight is 1.5 (half the length of the side of the square) cm from the reflector and is parallel to the plate. The side of the square along the midline of the copper core of the emitter is 30.5 mm. True, the antenna for Wi-Fi will be smaller in size. The lower half is planted on the ground, the upper half - on the signal core of the cable RK - 50. It turns out something resembling trendy glasses with a thin bridge in the middle. The Wi-Fi antenna, built according to the biquad scheme, is formed by a grounded reflector, a figure-eight emitter with right (90 degrees) angles. Soon the textolite will be tightly covered with a polymer film. Put on a reflector “fur coat”, blow with a hair dryer. Important! Try using shrink wrap for protection. Do-it-yourself Wi-Fi antenna for any bad weather! Today's review is devoted to methods for improving the design. The wind load on the product will increase.
A board with double-sided foil, which is often recommended to be used as a reflector, does not tolerate bad weather very well, is not protected by anything, it is problematic to supply the design with a special case. It was mentioned: instead of a traditional wire, it is better to take a PV1 wire of a similar section, which protects the installed antenna from bad weather. People with enviable constancy are looking for a chance to get a better design. We touched upon the designs of a directional Wi-Fi antenna earlier.
0 kommentar(er)
